![]() |
Have you had your vet to check her to make sure she doesn't have a stricture? AI could be done. I would have her checked to make sure she doesn't have a stricture, in case she does get pregnant you want to be aware of wether she can have the pups naturally or would need a CSection due to the stricture.. Deana Prestigeous |
What is a stricture |
Quote:
|
I really think you are worrying too much. You were able to get one tie so there is a good possibility that she will be pregnant. I would just wait and see the outcome of this breeding. Like I said before, sometimes the male just has a hard time getting the job done because of several different factors. I have had the same problem on a few occasions where we were only able to get one tie after many tries or just an outside tie and in those cases the female got pregnant and had puppies with no problems. Be sure to let us if she is pregnant. Best of luck to you. |
If you did manage a TIE then you are going to be OK now wether you have a pregnant girl or not, time will tell. I thought you are not able to get a tie, then I saw someone talking about an outside tie. Are you going to try her again to see if you can get a tie? Some girls are actually ready later in their cycle than others. Keep us posted Deana Prestigeous Yorkies |
I am having this problem right now and am new to Yorkie Breeding. I used to breed boxers. What is an outside tie. I have never heard of this? |
An outside tie is when then the male penetrates the female, knots up and is ejaculating but the males bulb is on the outside of the female but you are able to hold the male in place on the female so the penis does not slip out. Usually if a male knots up on the outside of the female his penis will slip out when he dismounts unless you are there to hold him in place. Females are able to get pregnant with an outside tie if you are able to hold them in place long enough. I have found that young and inexperienced males seem to do this more often than the experienced ones. |
Quote:
|
Hi there. just wanted to say we had an outside tie - and the results were three beautiful little boys. So keep you fingers crossed! and good luck. |
Quote:
|
Quote:
|
Whoo hoo we had our 1st tie. BUt it only lasted about 1min. Is that normal. Our boxer were sometimes 15-20 min?? I'm new to breeding yorkies. I thought it would have been a bit longer. They both also first timers. DOes that make a difference? TX I would think any kind of lube would be good. Just as long as their is no spermacide. HJust have to read the label. |
tie Try for at least 3 mins...there are three fractions to the ejaculate..but one min can be enough. Hold his rear end against the bitch to prevent him from pulling back out for a few more minutes...and hold the bitch, arm around and under her belly..doing that, no one moves. |
Day 9, for the majority of Yorkies - is too early to breed. Also with a small stud it is unadvisable to let him do this all by himself as he can be injuries. The girl should be held, with the index and middle finger of one hand on each side of her vulva and the other hand holding her front leg. This way you can tell exactly where the stud is "hitting" and how firmly and make adjustments as needed. With a maiden girl - the male must "hit" her firmly in order to both enter the vulva and to break the hymen. When entrance has been made, I grab the male under the base of his tail and pull toward me in order to push him in farther and hold him there for a moment or so until the tie is accomplished. After that I just hold the girl and talk to both of them until it is over. (Sometimes up to an hour) It is a good idea to use a very experienced stubd with a maiden as an inexperienced one often doesn't have the aim and patience down yet.:) FYI - The girl isn't ready to be bred until her discharge has turned to straw color (or in some cases has stopped) and the vulva has begun to soften. The average day for my girls is from 12 to 14 days from start of color. If you do saliva slides - the ferning should be well on its way when the time to breed is right. Best of luck! Charlie |
Quote:
|
| All times are GMT -8. The time now is 12:16 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Copyright ©2003 - 2018 YorkieTalk.com
Privacy Policy - Terms of Use